Modeling and Validation of Generation Units in Accordance with Technical Guideline FGW TR 4

Validated simulation models and precise laboratory measurements are required for the certification of generation units (EZE). We develop root mean square (RMS) models as well as models for electromagnetic transients (EMT models) that realistically simulate the electrical behavior of generation units, and we support the validation process through to certification. In addition to modeling based on measurement data and technical specifications, we offer accelerated model creation using the source code of the EZE control system, for example by integrating the control algorithms as a dynamic link library (DLL). This protects the intellectual property of the software while allowing the simulation model to be easily shared with certification bodies, grid operators, and project partners.

As part of our DAkkS-accredited scope of services, we prepare validation reports in accordance with FGW TG 4 for use in the certification process. This enables us to provide laboratory measurements, model development, and model validation all from a single source - reducing coordination effort and shortening processing times.

Model Development

© Fraunhofer ISE
Simulation development based on measurement data, followed by validation.

We develop RMS and EMT models that simulate the electrical behavior of power generating units, including inverter-based systems. These models can be used for certifications in accordance with FGW TG 4 as well as international standards such as G99 or AS/NZS. Depending on the requirements, we use tools such as DIgSILENT PowerFactory, MATLAB/Simulink, and PSCAD. Our work is based on measurement data and technical specifications provided by the customer, or alternatively, on the firmware source code of the control system. For source-code-based modeling, we extract and compile the relevant control algorithms, for example as DLLs. This accelerates the model development process without disclosing the software IP. You receive a ready-to-use model, including documentation and support throughout the certification process. 

Model Validation

Comparison of simulation and measurement results following a change in the reactive-power setpoint, used to verify the steady-state characteristics of a power-generating unit.
© Fraunhofer ISE
Comparison of simulation and measurement results following a change in the reactive-power setpoint, used to verify the steady-state characteristics of a power-generating unit.

We validate simulation models of power generating units in accordance with FGW TG 4 –both models developed in-house and existing customer models. Validation includes, among other things, fault ride-through (FRT) tests, steady-state characteristics, and plausibility checks. In this process, we systematically compare the simulated behavior with the results from laboratory measurements and evaluate the agreement against the applicable requirements. As part of our accredited scope of services, we prepare validation reports that can be used for certification. If desired, we work directly with the certification bodies that issue the unit certificate.